KSduino 

 The Device Network
ABOUT | BLOG | FORUM | DOWNLOADS | DEVELOPMENT | DEVICES | DONATE | USER
Your IP Address is:

BLOG

  • KSduino can connect your Arduino with ENC28J60

    Posted on Sun December 23, 2012

    This allows you to add internet capability to your project. It can also be used to drive relays as only a few pins are used for the ENC28J60.

    KSduino can connect your Arduino with ENC28J60

    About ENC28J60:

    The ENC28J60 Ethernet Module utilizes the new Microchip ENC28J60 Stand-Alone Ethernet Controller IC featuring a host of features to handle most of the network protocol requirements. The board connects directly to Arduino and to most microcontrollers with a standard SPI interface with a transfer speed of up to 20MHz.

    The ENC28J60 contains all the necessary hardware to implement an Ethernet interface including the isolation transformer and LINK/STATUS LEDs. SPI interface makes this one of the easiest 10Base-T ICs yet! 3.3V with 8KB buffer.

    image

    The ENC28J60 is fully compatible with KSduino. ENC28J60 performance is not inferior to the standard Arduinos w5100 Ethernet Shield. One of the biggest factors of using ENC28J60 device is its low cost.

    Where to buy ENC28J60:

    Use online shopping to by it

    etc, there are so many offers. Or look it in your local shops.

    Hardware connection ENC28J60 to Arduino:

    ENC28J60 has 10 pins, but it used only 7 pins to connect ENC28J60 to Arduino. The ENC28J60 use standard SPI interface so you can connect 5 pins to the Arduinos ICSP connector one pin to the 3.3V and another one to the pin 8 (this is EtherCard library default ChipSelect (CS) pin).

    Use this link for additional information: http://ksdu.in/o/1c

    How to connect ENC28J60 to KSduino:

    To connect this device to KSduino we have used KSduino Library for Arduino with ENC28J60 and EtherCart Ethernet library. The EtherCat Ethernet library supports all the functions of ENC28J60 Ethernet Shield and has its own very interesting examples. The KSduino library uses EtherCart UDP stack and allows uses of all functions of KSduino and EtherCart libraries.

    Follow the instructions to download the librarys in the DEVELOPMENT page.

    See also:


    Best regards,
    Kirill Scherba
    The founder and main developer of KSduino project.

    P.S. The short links was created with our new URL Shortener: http://ksdu.in/o/






  • comments powered by Disqus
Created with KSNews

HOME | CONTACTS | INFORMER | SHORTENER | DOCUMENTATION | HELP

Copyright © 2012-2013, The KSduino Project